Yttria Tetragonal Zirconia Biomaterials: Kinetic Investigation

Abstract

Abstract: The low temperature aging behavior of polycrystalline tetragonal zirconia was investigated to explore the effects on phase transformation occurring during the process. XRD analysis was conducted for the phase identification and the tetragonal to monoclinic phase transformation was determined. The aging of tetragonal zirconia polycrystals doped with 3 mol% Y₂O₃ triggers tetragonal to monoclinic phase transformation on the surface of the specimen only, while the penetration inside the bulk of the specimen is very limited. A slight decrease in the mechanical properties was also observed after aging for 40 h. The transformation kinetics show a nucleation and growth mechanism on the specimen surface to be dominant in the low temperature aging in water environment.

Key words: Low temperature degradation, 3Y-TZP, Kinetics

Ezzat S. Elshazly, S.M. El-Hout, M. El-Sayed Ali. Yttria Tetragonal Zirconia Biomaterials: Kinetic Investigation[J]. J Mater Sci Technol, 2011, 27(4): 332-337.

References

[1 ] S. Ran, A.J.A. Winnubst, H. Koster, P.J. de Veen and D.H.A. Blank: J. Eur. Ceram. Soc., 2007, 27, 683.

[2 ] A.R. Studart, F. Filser, P. Kocher and L.J. Gauckler: Biomaterials, 2007, 28, 2695.

[3 ] S. Pilathadka, D. Vahalova and T. Voshlo: Prague Medical Report, 2007, 108(1), 5.

[4 ] C. Piconi, G. Maccauro, F. Muratori and E.B. Del Prever: J. Appl. Biomater. Biomech., 2003, 1, 19.

[5 ] I.C. Clarke, M. Manaka, D.D. Green, P. Williams, G. Pezzotti, Y.H. Kim, M. Ries, N. Sugano, L. Sedel, C. Delauney, B. Ben Nissan, T. Donaldson and G.A. Gustafson: J. Bone Joint Surg., 2003, 85, 73.

[6 ] J.J. Payyapilly and D.P. Butt: J. Nucl. Mater., 2007, 360, 92.

[7 ] W.D. Kingery, H.K. Bowen and D.R. Uhlmann: Introduction to Ceramics, Wiley, New York, USA, 1976.

[8 ] R.C. Garvie, R.H.J. Hannink and R.T. Pascoe: Nature, 1975, 258, 703.

[9 ] I. Thompson and R.D. Rawlings: Biomaterials, 1990, 11, 505.

[10] M. Guazzato, M. Albakry, S. Ringer and M. Swain: Dent. Mater., 2004, 20(5), 449.

[11] J.J. Swab: J. Mater. Sci., 1991, 26, 6706.

[12] R.A. Kimel and J.H. Adair: J. Am. Ceram. Soc., 2002, 85(6), 1403.

[13] F.F. Lange, G.L. Dunlop and B.I. Davis: J. Am. Ceram. Soc., 1986, 69(3), 237.

[14] M. Yoshimura, T. Noma, K. Kawabata and S. Somiya: J. Mater. Sci. Lett., 1987, 6(4), 465.

[15] R.C. Garvie and P.S. Nicholson: J. Am. Ceram. Soc., 1972, 55, 152.

[16] R.H.J. Hannink, P. Kelly and B.C. Muddlle: J. Am. Ceram. Soc., 2000, 83(3), 461.

[17] J.F. Jue, J. Chen and V. Virkar: J. Am. Ceram. Soc., 1991, 74(8),1811.

[18] K. Tsukuma, Y. Kubota and T. Tsukidate: Advances in Ceramics, vol. 24, Science and Technology of Zirconia III, eds S. Somiya, N. Yamamato and H. Yanagida,

The American Ceramic Soc. Inc., Columbus, Ohio, 1984, 382-390.

[19] H. Schubert and G. Petzow: Advances in Ceramics, vol 24, Science and Technology of Zirconia III, eds S. Somiya, N. Yamamato and H. Yanagida, The American Ceramic Soc. Inc., Columbus, Ohio., 1988, 21-28.

[20] H. Schubert and F. Frey: J. Eur. Ceram. Soc., 2005, 25(9), 1597.

[21] J. Chevalier, S. Deville, E. MÄunch, R. Jullian and F. Lair: Biomaterials, 2004, 25(24), 5539.

[22] T. Sato and M. Shimada: J. Am. Ceram. Soc., 1985, 68(6), 356.

[23] J.F. Bartolome, I. Montero, M. Diaz, S. LopezEsteban, J.S. Moya, S. Deville, L. Gremillard, J. Chevalier and G. Fantozzi: J. Am. Ceram. Soc., 2004, 87(12), 2282.

[24] K. Grant and R.D. Rawlings: J. Mater. Sci. Lett., 1999, 18, 739.

[25] J. Chevalier, B. Cales and J. Drouin: J. Am. Ceram. Soc., 1999, 82(8), 2150.

[26] M. Avrami: J. Chem. Phys., 1939, 7(12), 103.

[27] M. Avrami: J. Chem. Phys., 1940, 8(2), 212.

[28] M. Avrami: J. Chem. Phys., 1941, 9(2), 177.

[29] W.A. Johnson and R.F. Mehl: Trans. Metall. Soc. AIME., 1939, 135, 416.

[30] S. Lawson: J. Eur. Ceram. Soc., 1995, 15, 485.

[1]	Qiang Ren, Yuexin Zhang, Ying Ren, Lifeng Zhang, Jujin Wang, Yadong Wang. Prediction of spatial distribution of the composition of inclusions on the entire cross section of a linepipe steel continuous casting slab [J]. J. Mater. Sci. Technol., 2021, 61(0): 147-158.
[2]	Yang Wang, Shun Zhang, Ruizhi Wu, Nodir Turakhodjaev, Legan Hou, Jinghuai Zhang, Sergey Betsofen. Coarsening kinetics and strengthening mechanisms of core-shell nanoscale precipitates in Al-Li-Yb-Er-Sc-Zr alloy [J]. J. Mater. Sci. Technol., 2021, 61(0): 197-203.
[3]	Di Zhang, Zhen Zhang, Yanlin Pan, Yanbin Jiang, Linzhong Zhuang, Jishan Zhang, Xinfang Zhang. Current-driving intergranular corrosion performance regeneration below the precipitates solvus temperature in Al-Mg alloy [J]. J. Mater. Sci. Technol., 2020, 53(0): 132-139.
[4]	Caiqin Zhou, Yayu Peng, Qingan Zhang. Growth kinetics of MgH₂ nanocrystallites prepared by ball milling [J]. J. Mater. Sci. Technol., 2020, 50(0): 178-183.
[5]	Dongjun Wang, Hao Li, Wei Zheng. Oxidation behaviors of TA15 titanium alloy and TiBw reinforced TA15 matrix composites prepared by spark plasma sintering [J]. J. Mater. Sci. Technol., 2020, 37(0): 46-54.
[6]	Gang Lu, Shuai Nie, Jianjun Wang, Ying Zhang, Tianhai Wu, Yujie Liu, Chunming Liu. Enhancing the bake-hardening responses of a pre-aged Al-Mg-Si alloy by trace Sn additions [J]. J. Mater. Sci. Technol., 2020, 40(0): 107-112.
[7]	Y.Z. Chen, X.Y. Ma, W.X. Zhang, H. Dong, G.B. Shan, Y.B. Cong, C. Li, C.L. Yang, F. Liu. Effects of dealloying and heat treatment parameters on microstructures of nanoporous Pd [J]. J. Mater. Sci. Technol., 2020, 48(0): 123-129.
[8]	Hui Pan, Liwei Wang, Yi Lin, Feng Ge, Kang Zhao, Xin Wang, Zhongyu Cui. Mechanistic study of ammonium-induced corrosion of AZ31 magnesium alloy in sulfate solution [J]. J. Mater. Sci. Technol., 2020, 54(0): 1-13.
[9]	Qun Luo, Yanlin Guo, Bin Liu, Yujun Feng, Jieyu Zhang, Qian Li, Kuochih Chou. Thermodynamics and kinetics of phase transformation in rare earth-magnesium alloys: A critical review [J]. J. Mater. Sci. Technol., 2020, 44(0): 171-190.
[10]	Qinghang Wang, Bin Jiang, Aitao Tang, Jie Fu, Zhongtao Jiang, Haoran Sheng, Dingfei Zhang, Guangsheng Huang, Fusheng Pan. Unveiling annealing texture formation and static recrystallization kinetics of hot-rolled Mg-Al-Zn-Mn-Ca alloy [J]. J. Mater. Sci. Technol., 2020, 43(0): 104-118.
[11]	Xinzeng Liang, Jing Bai, Jianglong Gu, Haile Yan, Yudong Zhang, Claude Esling, Xiang Zhao, Liang Zuo. Probing martensitic transformation, kinetics, elastic and magnetic properties of Ni_2-_xMn_1.5In_0.5Co_x alloys [J]. J. Mater. Sci. Technol., 2020, 44(0): 31-41.
[12]	Geng Liu, Zongbiao Dai, Zhigang Yang, Chi Zhang, Jun Li, Hao Chen. Kinetic transitions and Mn partitioning during austenite growth from a mixture of partitioned cementite and ferrite: Role of heating rate [J]. J. Mater. Sci. Technol., 2020, 49(0): 70-80.
[13]	Hui Yong, Shihai Guo, Zeming Yuan, Yan Qi, Dongliang Zhao, Yanghuan Zhang. Phase transformation, thermodynamics and kinetics property of Mg₉₀Ce₅RE₅ (RE = La, Ce, Nd) hydrogen storage alloys [J]. J. Mater. Sci. Technol., 2020, 51(0): 84-93.
[14]	Shujing Shi, Zhengwei Yan, Yongsheng Li, Suleman Muhammad, Dong Wang, Shi Chen, Shengshun Jin. Phase-field simulation of early-stage kinetics evolution of γ' phase in medium supersaturation Co-Al-W alloy [J]. J. Mater. Sci. Technol., 2020, 53(0): 1-12.
[15]	G.W. Hu, L.C. Zeng, H. Du, X.W. Liu, Y. Wu, P. Gong, Z.T. Fan, Q. Hu, E.P. George. Tailoring grain growth and solid solution strengthening of single-phase CrCoNi medium-entropy alloys by solute selection [J]. J. Mater. Sci. Technol., 2020, 54(0): 196-205.