J. Mater. Sci. Technol. ›› 2025, Vol. 227: 174-191.DOI: 10.1016/j.jmst.2024.12.023

• Research article • Previous Articles     Next Articles

Achieving superior strength and ductility synergy of WE54 alloy via combined dislocation introduction and twinning

Liuyong Hea,b, Jiang Zhenga,b,*, Qiyang Hea, Tianjiao Lic, Haoge Shoud, Dongdi Yine, Shengwen Baia, Bin Jianga,*, Fusheng Pana   

  1. aCollege of Materials Science and Engineering, Chongqing University, Chongqing 400044, China;
    bInternational Joint Laboratory for Light Alloys (Ministry of Education), College of Materials Science and Engineering, Chongqing University, Chongqing 400044, China;
    cState Key Laboratory of Advanced Processing and Recycling of Nonferrous Metals, Lanzhou University of Technology, Lanzhou 730050, China;
    dCollege of Intelligent Manufacturing, Huanghuai University, Zhumadian 463000, China;
    eKey Laboratory for Advanced Technologies of Materials, Ministry of Education, School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu 610031, China
  • Received:2024-11-11 Revised:2024-12-10 Accepted:2024-12-14 Online:2025-01-18
  • Contact: *E-mail addresses: jzheng@cqu.edu.cn (J. Zheng), jiangbinrong@cqu.edu.cn (B. Jiang).

Abstract: Aging precipitation can effectively enhance the strength of Mg-RE alloys, but it is usually accompanied by a significant decrease in ductility, thus the strength-ductility trade-off is a longstanding challenge. In this study, we report a new strategy that coupled pre-deformation (pre-tension along the extrusion direction (ED) followed by pre-compression along transverse direction (TD)) with artificial aging to achieve an exceptional strength-ductility synergy in the WE54 alloy at RT. We analyzed the microstructure, deformation modes and mechanical properties of four samples: T6 (artificial aging), PT-T6 (pre-tension + artificial aging), PC-T6 (pre-compression + artificial aging), and PTC-T6 (coupled pre-deformation + artificial aging). The PTC-T6 sample exhibited the superior strength-plasticity synergy, showing a strength increase of 111.9 MPa over the T6 sample and only a slight decrease in elongation to fracture. The PTC-T6 sample features finer and denser precipitates, along with a higher dislocation density, particularly a significant presence of <c+a> dislocations. This microstructural configuration enhances strength and facilitates the activation of pyramidal slip, which is the primary factor underlying its superior strength-ductility synergy.

Key words: Magnesium alloy, c+a> dislocation, Precipitation, Strength-ductility synergy, Deformation mode