Abstract: In engineering structures, the application of advanced alloys, such as the VCoNi medium-entropy alloy (VCoNi-MEA), with remarkable tensile strength (> 1 GPa) and superior ductility necessitates the employment of dissimilar joints. This study pioneers the dissimilar joining of VCoNi-MEA and 17-4 precipitation hardening stainless steel (17-4PH STS) using state-of-the-art green laser beam welding (LBW). To evaluate and optimize the experimental parameters, two welding speeds (200 and 300 mm/s) along with post-weld heat treatment (PWHT) were incorporated. High-quality welded joints with a single-phase face-centered cubic (FCC) structure in the fusion zone (FZ), minimal precipitates (< 1.6 %), and no visible cracks were successfully created. The LBW process demonstrated effective low-heat input characteristics, evident from a considerably narrow heat-affected zone (HAZ). Control over FZ width and grain size was achieved, measuring 600 and 112 µm at low welding speed and 250 and 49 µm at high welding speed, respectively, significantly lower than previous studies. A remarkably high yield strength (YS) of ∼620 MPa and ultimate tensile strength (UTS) up to 845 MPa were observed in the as-welded conditions, improving to ∼645 and 875 MPa, respectively, after PWHT. This enhancement in mechanical properties is primarily attributed to lattice friction induced by V addition. PWHT also improved joint ductility, increasing from 3.5 % to 8.6 % (low-speed) and from 6.3 % to 9.2 % (high-speed). The reduction in crystallographic orientation achieved using a higher welding speed and PWHT emerged as a major reason for improved mechanical properties. Slip-based deformation mechanisms dominated across all conditions, featuring crystallographically aligned slip bands. Interactions between existing and additional slip bands formed a dense dislocation network crucial for enhanced elongation after PWHT. Thermodynamic parameters elucidating phase stability in the observed FZs and contributions to superior YS were calculated and comprehensively discussed.

Key words: Medium-entropy alloys, Precipitation hardening stainless steel, Dissimilar laser beam welding, Green laser, Mechanical properties, Post-weld heat treatment