Hydrogen Storage Kinetics of Nanocrystalline and Amorphous LaMg12-Type Alloy-Ni Composites Synthesized by Mechanical Milling

doi:10.1016/j.jmst.2015.12.005

J. Mater. Sci. Technol. ›› 2016, Vol. 32 ›› Issue (3): 218-225.DOI: 10.1016/j.jmst.2015.12.005

Previous Articles Next Articles

Hydrogen Storage Kinetics of Nanocrystalline and Amorphous LaMg₁₂-Type Alloy-Ni Composites Synthesized by Mechanical Milling

Yanghuan Zhang^{1, 2}, Baowei Li¹, Huiping Ren¹, Tai Yang², Shihai Guo², Yan Qi², Dongliang Zhao²

1 Key Laboratory of Integrated Exploitation of Baiyun Obo Multi-Metal Resources, Inner Mongolia University of Science and Technology, Baotou 014010, China;
2 Department of Functional Material Research, Central Iron and Steel Research Institute, Beijing 100081, China

Received:2015-09-02 Revised:2015-11-11 Online:2016-03-10
Contact: Prof., Ph.D.; Tel.: +86 10 62183115; Fax: +86 10 62187102.E-mail address: zhangyh59@sina.com (Y. Zhang).
Supported by:
This work is financially supported by the National Natural Science Foundation of China (Grant Nos. 51161015 and 51371094).

Abstract

Abstract: The nanocrystalline and amorphous LaMg₁₁Ni + x wt% Ni (x = 100, 200) composites were synthesized by the mechanical milling, and their gaseous and electrochemical hydrogen storage kinetics performance were systematically investigated. The results indicate that the as-milled composites exhibit excellent hydrogen storage kinetic performances, and increasing Ni content significantly facilitates the improvement of the hydrogen storage kinetics properties of the composites. The gaseous and electrochemical hydrogen storage kinetics of the composites reaches a maximum value with the variation of milling time. Increasing Ni content and milling time both make the hydrogen desorption activation energy lower, which are responsible for the enhancement in the hydrogen storage kinetics properties of the composites. The diffusion coefficient of hydrogen atom and activation enthalpy of charge transfer on the surface of the as-milled composites were also calculated, which are considered to be the dominated factors for the electrochemical high rate discharge ability.

Key words: LaMg12 alloy, Mechanical milling, Activation energy, Hydrogen storage kinetics

Yanghuan Zhang, Baowei Li, Huiping Ren, Tai Yang, Shihai Guo, Yan Qi, Dongliang Zhao. Hydrogen Storage Kinetics of Nanocrystalline and Amorphous LaMg₁₂-Type Alloy-Ni Composites Synthesized by Mechanical Milling[J]. J. Mater. Sci. Technol., 2016, 32(3): 218-225.

References

[1] D. Mori, K. Hirose, Int. J. Hydrogen Energy 34 (2009) 4569-4574.
[2] DOE Office of Energy Efficiency and Renewable Energy Hydrogen, Fuel cells & infrastructure technologies program multi-year research, Development and Demonstration Plan, Available from: <http://www.eere.energy.gov/hydrogenandfuelcells/mypp>, 2009 (accessed 02.09.15).
[3] T. Umegaki, J.M. Yan, X.B. Zhang, H. Shioyama, N. Kuriyama, Q. Xu, Int. J. Hydrogen Energy 34 (2009) 2303-2311.
[4] A. Ebrahimi-Purkani, S.F. Kashani-Bozorg, J. Alloy. Compd. 456 (2008) 211-215.
[5] Y.Wang, X.Wang, C.M. Li, Int. J. Hydrogen Energy 35 (2010) 3550-3554.
[6] S. Kalinichenka, L. Röntzsch, T. Riedl, T. Gemming, T. Weißgärber, B. Kieback, Int. J. Hydrogen Energy 36 (2011) 1592-1600.
[7] L. Mendoza-Zélis, M. Meyer, L. Baum, Int. J. Hydrogen Energy 36 (2011) 600-605.
[8] L. Zaluski, A. Zaluska, J.O. Strom-Olsen, J. Alloy. Compd. 253-254 (1997) 70-79.
[9] L.H. Kumar, B. Viswanathan, S.S. Murthy, J. Alloy. Compd. 461 (2008) 72-76.
[10] A.A. Poletaev, R.V. Denys, J.K. Solberg, B.P. Tarasovd, V.A. Yartys, J. Alloy. Compd.509S (2011) S633-S639.
[11] Y.Wang, S.Z. Qiao, X.Wang, Int. J. Hydrogen Energy 33 (2008) 1023-1027.
[12] H.J. Yuan, Y. An, G.H. Xu, C.P. Chen, Mater. Chem. Phys. 83 (2004) 340-344.
[13] M. Abdellaoui, S. Mokbli, F. Cuevas, M. Latroche, A. Percheron-Guégan, H.Zarrouk, J. Alloy. Compd. 356-357 (2003) 557-561.
[14] A. Teresiak, A. Gebert, M. Savyak, M. Uhlemann, C. Mickel, N. Mattern, J. Alloy. Compd. 398 (2005) 156-164.
[15] M. Anik, F. Karanfil, N. Küçükdeveci, Int. J. Hydrogen Energy 37 (2012) 299-308.
[16] Y.Wu,W. Han, S.X. Zhou, M.V. Lototsky, J.K. Solberg, V.A. Yartys, J. Alloy. Compd.466 (2008) 176-181.
[17] D.H. Xie, P. Li, C.X. Zeng, J.W. Sun, X.H. Qu, J. Alloy. Compd. 478 (2009) 96-102.
[18] M. Anik, J. Alloy. Compd. 491 (2010) 565-570.
[19] M.Y. Song, C.D. Yim, S.N. Kwon, J.S. Bae, S.H. Hong, Int. J. Hydrogen Energy. 33 (2008) 87-92.
[20] T. Sadhasivam, M.S. Leo Hudson, S.K. Pandey, A. Bhatnagar, M.K. Singh, K. Gurunathan, O.N. Srivastava, Int. J. Hydrogen Energy 38 (2013) 7353-7362.
[21] M. Avrami, J. Chem. Phys. 7 (1939) 1103-1112.
[22] J.F. Fernandez, C.R. Sanchez, J. Alloy. Compd. 356-357 (2003) 348-352.
[23] H.E. Kissinger, Anal. Chem. 29 (1957) 1702-1706.
[24] M. Baricco, M.W. Rahman, S. Livraghi, A. Castellero, S. Enzo, E. Giamello, J. Alloy.Compd. 536S (2012) S216-S221.
[25] X.Y. Zhao, Y. Ding, L.Q. Ma, L.Y.Wang, M. Yang, X.D. Shen, Int. J. Hydrogen Energy. 33 (2008) 6727-6733.
[26] N. Kuriyama, T. Sakai, H. Miyamura, I. Uehara, H. Ishikawa, T. Iwasaki, J. Alloy.Compd. 202 (1993) 183-197.
[27] G. Zheng, B.N. Popov, R.E. White, J. Electrochem. Soc. 142 (1995) 2695-2698.
[28] Y.H. Zhang, C. Li, Y. Cai, F. Hu, Z.C. Liu, S.H. Guo, J. Alloy. Compd. 584 (2014)81-86.

Hydrogen Storage Kinetics of Nanocrystalline and Amorphous LaMg₁₂-Type Alloy-Ni Composites Synthesized by Mechanical Milling

RichHTML

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments

[1]	Shikai Wu, Ye Pan, Jie Lu, Ning Wang, Weiji Dai, Tao Lu. Effect of the addition of Mg, Ti, Ni on the decoloration performance of AlCrFeMn high entropy alloy [J]. J. Mater. Sci. Technol., 2019, 35(8): 1629-1635.
[2]	Yanghuan Zhang, Pengpeng Wang, Zhonghui Hou, Zeming Yuan, Yan Qi, Shihai Guo. Structure and hydrogen storage characteristics of as-spun Mg-Y-Ni-Cu alloys [J]. J. Mater. Sci. Technol., 2019, 35(8): 1727-1734.
[3]	Min Zha, Hong-Min Zhang, Zhi-Yuan Yu, Xuan-He Zhang, Xiang-Tao Meng, Hui-Yuan Wang, Qi-Chuan Jiang. Bimodal microstructure - A feasible strategy for high-strength and ductile metallic materials [J]. J. Mater. Sci. Technol., 2018, 34(2): 257-264.
[4]	Zeming Yuan, Bangwen Zhang, Yanghuan Zhang, Shihai Guo, Xiaoping Dong, Dongliang Zhao. A comparison study of hydrogen storage properties of as-milled Sm₅Mg₄₁ alloy catalyzed by CoS₂ and MoS₂ nano-particles [J]. J. Mater. Sci. Technol., 2018, 34(10): 1851-1858.
[5]	F.Q. Lang, H. Yamaguchi, H. Nakagawa, H. Sato. Solid-State Interfacial Reaction between Eutectic Au-Ge Solder and Cu/Ni(P)/Au Metalized Ceramic Substrate and Its Suppression [J]. J. Mater. Sci. Technol., 2015, 31(5): 445-452.
[6]	Shuming Wang, Fenghua Kuang, Dazhan Zhang, Xu Zhou, Minghui Tang. Crystallization Behavior of Nd₂O₃ Doped Na₂O-CaO-SiO₂ Laser Glass-ceramics [J]. J. Mater. Sci. Technol., 2015, 31(11): 1158-1160.
[7]	W. Blum, J. Dvořák, P. Král, P. Eisenlohr, V. Sklenička. Correct Interpretation of Creep Rates: A Case Study of Cu [J]. J. Mater. Sci. Technol., 2015, 31(11): 1065-1068.
[8]	Taghi Dallali Isfahani, Jafar Javadpour, Alireza Khavandi, Massoud Goodarzi,Hamid Reza Rezaie. Nanocrystalline Growth Activation Energy of Zirconia Polymorphs Synthesized by Mechanochemical Technique [J]. J. Mater. Sci. Technol., 2014, 30(4): 387-393.
[9]	Y. Mazaheri, F. Karimzadeh, M.H. Enayati. Development of Al356-Al₂O₃ Nanocomposite Coatings by High Velocity Oxy-fuel Technique [J]. J. Mater. Sci. Technol., 2013, 29(9): 813-820.
[10]	Meiting Xie, Pengna Zhang, Kaikai Song. Thermal Stability and Transformation-mediated Deformability of Cu-Zr-Al-Ni Bulk Metallic Glass Composite [J]. J. Mater. Sci. Technol., 2013, 29(9): 868-872.
[11]	Chenggang Tian, Chuanyong Cui, Ling Xu, Yuefeng Gu, Xiaofeng Sun. Dynamic Strain Aging in a Newly Developed Ni-Co-Base Superalloy with Low Stacking Fault Energy [J]. J. Mater. Sci. Technol., 2013, 29(9): 873-878.
[12]	Ming Luo, Yawei Li, Shengli Jin, Shaobai Sang, Lei Zhao. Microstructural Evolution and Oxidation Resistance of Multi-walled Carbon Nanotubes in the Presence of Silicon Powder at High Temperatures [J]. J Mater Sci Technol, 2012, 28(7): 599-605.
[13]	H.B. Motejadded, M. Soltanieh, S. Rastegari. Coarsening Kinetics of γ′ Precipitates in Dendritic Regions of a Ni₃Al Base Alloy [J]. J Mater Sci Technol, 2012, 28(3): 221-228.
[14]	Niwat Mookam, Kannachai Kanlayasiri. Evolution of Intermetallic Compounds between Sn-0.3Ag-0.7Cu Low-silver Lead-free Solder and Cu Substrate during Thermal Aging [J]. J Mater Sci Technol, 2012, 28(1): 53-59.
[15]	B. Xu, W.P. Tong, C.Z. Liu, H. Zhang, L. Zuo, J.C. He. Effect of High Magnetic Field on Growth Behavior of Compound Layers during Reactive Diffusion between Solid Cu and Liquid Al [J]. J Mater Sci Technol, 2011, 27(9): 856-860.