J. Mater. Sci. Technol. ›› 2021, Vol. 92: 11-20.DOI: 10.1016/j.jmst.2021.03.022

• Research Article • Previous Articles     Next Articles

Effect of grain boundary precipitates on the stress rupture properties of K4750 alloy after long-term aging at 750 °C for 8000 h

Meiqiong Oua, Yingche Maa,*(), Kunlei Houa,b, Min Wanga, Guangcai Maa, Kui Liua,*()   

  1. aShi-changxu Innovation Center for Advanced Materials, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, China
    bSchool of Materials Science and Engineering, University of Science and Technology of China, Hefei 230026, China
  • Received:2020-11-25 Revised:2021-03-15 Accepted:2021-03-15 Published:2021-11-30 Online:2021-04-28
  • Contact: Yingche Ma,Kui Liu
  • About author:kliu@imr.ac.cn (K. Liu).
    * E-mail addresses: ycma@imr.ac.cn (Y. Ma),

Abstract:

In K4750 alloy, the evolution of grain boundary (GB) precipitates, including the degradation of blocky MC carbide particles and the precipitation of granular/needle-like η phase particles, were observed after long-term aging (LA) at 750°C for 8000 h. During MC degradation, the Ti and C released from the MC carbide combined with Ni and Cr, respectively, in the γ matrix to form η-Ni3Ti phase and Cr-rich M23C6 carbide. Large amounts of granular η phase precipitated at GBs and the needle-like η phase grew gradually from GBs toward the grain interior. Because of the growth of the η phase through absorbing γ′ phase, γ′-depleted zones were formed around the η phase. The evolution of the MC carbide and η phase was primarily responsible for the decrease of the stress rupture life and the increase of elongation. After an LA sample was tested at 750°C and 360 MPa, the residual strain distribution was investigated by electron backscatter diffraction (EBSD). The results showed that the residual strain mainly distributed at GBs, especially in the region of MC degradation and at the edges of η phases, which was closely related to the appearance of phase interfaces. Microvoids/cracks easily initiated at phase interfaces, then easily extended along the γ′-depleted zones, thus the stress rupture life of LA samples was substantially shorter than that of samples subjected to the standard treatment. In particular, because of large amounts of fine degraded MC, granular M23C6 and granular η phase particles distributed at GBs after 750°C /8000 h LA and microvoid/crack formation could be hindered by the formation of dimples, which led to an increase of elongation.

Key words: Ni-base superalloy, Long-term aging, MC carbide, η phase, Stress rupture properties, Residual strain distribution