J. Mater. Sci. Technol. ›› 2021, Vol. 95: 225-236.DOI: 10.1016/j.jmst.2021.03.077

• Research Article • Previous Articles     Next Articles

Low-temperature superplasticity of β-stabilized Ti-43Al-9V-Y alloy sheet with bimodal γ-grain-size distribution

Yu Zhanga, Shuai Changb, Yuyong Chenc,d, Yuchao Baia, Cuiling Zhaoa, Xiaopeng Wangb, Jun Min Xueb, Hao Wanga,*()   

  1. aDepartment of Mechanical Engineering, Faculty of Engineering, National University of Singapore, 9 Engineering Drive 1, Singapore 117575, Singapore
    bDepartment of Materials Science and Engineering, Faculty of Engineering, National University of Singapore, 9 Engineering Drive 1, Singapore 117576, Singapore
    cState Key Laboratory of Advanced Welding and Joining, Harbin Institute of Technology, Harbin 150001, China
    dNational Key Laboratory for Precision Hot Processing of Metals, Harbin Institute of Technology, Harbin 150001, China
  • Received:2021-01-05 Revised:2021-03-19 Accepted:2021-03-31 Published:2021-12-30 Online:2021-06-01
  • Contact: Hao Wang
  • About author:* E-mail address: mpewhao@nus.edu.sg (H. Wang).

Abstract:

The superplasticity of Ti-43Al-9V-0.2Y alloy sheet hot-rolled at 1100 °C was systematically investigated in the temperature range of 750-900 °C under an initial strain rate of 10-4 s-1. A bimodal γ grain-distribution microstructure of TiAl alloy sheet, with abundant nano-scale or sub-micron γ laths embedded inside β matrix, exhibits an impressive superplastic behaviour. This inhomogeneous microstructure shows low-temperature superplasticity with a strain-rate sensitivity exponent of m = 0.27 at 800 °C, which is the lowest temperature of superplastic deformation for TiAl alloys attained so far. The maximum elongation reaches ~360% at 900 °C with an initial strain rate of 2.0 × 10-4 s-1. To elucidate the softening mechanism of the disordered β phase during superplastic deformation, the changes of phase composition were investigated up to 1000 °C using in situ high-temperature X-ray diffraction (XRD) in this study. The results indicate that β phase does not undergo the transformation from an ordered L20 structure to a disordered A2 structure and cannot coordinate superplastic deformation as a lubricant. Based on the microstructural evolution and occurrence of both γ and β dynamic recrystallization (DR) after tensile tests as characterized with electron backscatter diffraction (EBSD), the superplastic deformation mechanism can be explained by the combination of DR and grain boundary slipping (GBS). In the early stage of superplastic deformation, DR is an important coordination mechanism as associated with the reduced cavitation and dislocation density with increasing tensile temperature. Sufficient DR can relieve stress concentration arising from dislocation piling-up at grain boundaries through the fragmentation from the original coarse structures into the fine equiaxed ones due to recrystallization, which further effectively suppresses apparent grain growth during superplastic deformation. At the late stage of superplastic deformation, these equiaxed grains make GBS prevalent, which can effectively avoid intergranular cracking and is conducive to the further improvement in elongation. This study advances the understanding of the superplastic deformation mechanism of intermetallic TiAl alloy.

Key words: Titanium aluminides, Hot-rolled alloy sheet, Bimodal microstructure, In situ high-temperature XRD, Superplasticity