Abstract: L1₂ precipitates are known to significantly enhance the strength and ductility of single-phase face-centered cubic (FCC) medium- or high-entropy alloys (M/HEAs). However, further improvements in mechanical properties remain untapped, as alloy design has historically focused on systems with specific CrCoNi- or FeCoCrNi-based FCC matrix and Ni₃Al L1₂ phase compositions. This study introduces novel Co-Ni-Mo-Al alloys with L1₂ precipitates by systematically altering Al content, aiming to bridge this research gap by revealing the strengthening mechanisms. The (CoNi)₈₁Mo₁₂Al₇ alloy achieves yield strength of 1086 MPa, tensile strength of 1520 MPa, and ductility of 35 %, demonstrating an impressive synergy of strength, ductility, and strain-hardening capacity. Dislocation analysis via transmission electron microscopy, supported by generalized stacking fault energy (GSFE) calculations using density functional theory (DFT), demonstrates that Mo substitution for Al in the L1₂ phase alters dislocation behavior, promoting the formation of multiple deformation modes, including stacking faults, super-dislocation pairs, Lomer-Cottrell locks, and unusual nano-twin formation even at low strains. These behaviors are facilitated by the low stacking fault energy (SFE) of the FCC matrix, overlapping of SFs, and dislocation dissociation across anti-phase boundaries (APBs). The increased energy barrier for superlattice intrinsic stacking fault (SISF) formation compared to APBs, due to Mo substitution, further influences dislocation activity. This work demonstrates a novel strategy for designing high-performance M/HEAs by expanding the range of FCC matrix and L1₂ compositions through precipitation hardening.

Key words: Medium entropy alloy, L1₂ nano-precipitate, Nano-twin, Strain-hardening capability, DFT calculation