Abstract: A glassy (G) phase was formed for Zr-rich Zr_70-75(Al, Ni, Cu, Ag)_25-30 (atomic percent, at.%) melt-spun alloy ribbons. These glassy alloys exhibit the glass transition, followed by a supercooled liquid region and then three-stage crystallization. The glass transition temperature and the onset temperature for the first-stage crystallization (T_x1) decrease from 630 to 668 K, respectively for the 70Zr alloy to 619 and 652 K, respectively for the 75Zr alloy. The first-stage exothermic peak is due to the precipitation of an icosahedral quasicrystal (IQ) phase. The IQ particle size decreases from 10 nm to 6 nm with increasing Zr content from 70 at.% to 74 at.%. The [G + IQ] phases change to Zr₂Ni + Zr₂(Cu, Ag) phases after the second exothermic peak and then Zr₂Ni + Zr₂(Cu, Ag) + Zr₅Al₃ phases after the third stage. It is noticed that the as-spun glassy alloy ribbons as well as the annealed [G + IQ] phase ribbons exhibit good bending plasticity. Furthermore, the 70Zr thicker ribbons also exhibit high tensile fracture strength of 1090-1187 MPa and plastic elongation of 0.17 %-0.42 %. The fracture mode is similar to that of ordinary bulk metallic glasses. The Vickers hardness (Hv) is 480 for 70Zr alloy and decreases to 436 for 75Zr alloy. The precipitation of IQ phase causes a significant increase in Hv to about 554. The formations of glassy alloys with high Zr contents of 70 at.%-75 at.% by melt spinning as well as the [G + IQ] phase alloys with good bending plasticity by annealing hold promise for the creation of a new type of engineering material, transcending mere academic novelty.

Key words: Pseudo-high entropy glassy alloy, Icosahedral quasicrystal, Plasticity, Mechanical property