J. Mater. Sci. Technol. ›› 2024, Vol. 194: 63-74.DOI: 10.1016/j.jmst.2024.01.026

• Research Article • Previous Articles     Next Articles

Nanoscale viscoelastic transition from solid-like to liquid-like enables ductile deformation in Fe-based metallic glass

C.B. Jina,b,1, Y.Z. Wub,1, J.N. Wangb, F. Hanb, M.Y. Tanb, F.C. Wangb, J. Xub, J. Yic, M.C. Lia,*, Y. Zhangb, J.T. Huob, J.Q. Wangb,*, M. Gaob,*   

  1. aSchool of Materials Science and Engineering, Xinjiang Key Laboratory of Solid State Physics and Devices & School of Physical Science and Technology, Xinjiang University, Urumqi 830046, China;
    bCAS Key Laboratory of Magnetic Materials and Devices, and Zhejiang Province Key Laboratory of Magnetic Materials and Application Technology, Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Sciences, Ningbo 315201, China;
    cInstitute of Materials, School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
  • Received:2023-11-28 Revised:2024-01-20 Accepted:2024-01-24 Published:2024-09-20 Online:2024-02-28
  • Contact: *E-mail addresses: limingcan@xju.edu.cn (M.C. Li), jqwang@nimte.ac.cn (J.Q. Wang), gaomeng@nimte.ac.cn (M. Gao).
  • About author:1These authors contributed equally to this work.

Abstract: The cooling rate during vitrification is critical for determining the mechanical properties of metallic glasses. However, the structural origin of the cooling rate effect on mechanical behaviors is unclear. In this work, a systematical investigation of the cooling rate effect on the deformation mode, shear band nucleation, and nanoscale heterogeneous structure was conducted in three Fe-based metallic glasses. The brittle to ductile deformation transition was observed when increasing the cooling rate. Meanwhile, the governing shear band nucleation site from high load site to low load site appears the synchronous transition. By studying the corresponding nanoscale heterogeneous structure, it was found that nanoscale viscoelastic transition from solid-like to liquid-like as increasing cooling rate enables ductile deformation. The current work not only reveals the nanoscale structural origin of the cooling rate effect on the deformation behaviors, but also provides a new route to design ductile metallic glasses by freezing more nanoscale liquid-like regions during cooling.

Key words: Metallic glass, Cooling rate, Deformation mode, Shear band, Nanoscale viscoelastic heterogeneity