Abstract: Wire arc additive manufacturing (WAAM) technique is a promising approach to producing large-scale metal components due to high deposition efficiency and low production cost. However, fundamental research about WAAM-processed Al-Mg-Sc-Zr alloy was still fewer. In this study, Al-6.54Mg-0.36Sc-0.11Zr (wt%) components were successfully manufactured by WAAM with an interlayer temperature at 100 °C (named IW) and continuous printing (named CP), and the corresponding porosity, microstructure, and mechanical properties of components were studied in detail. The porosity of components as-deposited was relatively low, about 0.385% and 0.116%, respectively. The microstructures of the two components exhibited the same distribution characteristics in XZ and YZ planes: fine equiaxed grains (FEG) at remelted zone + FEG and coarse equiaxed grain (CEG) alternative distribution at middle zone + FEG at the top zone of the molten pool. The average grain size of component IW was about 10.51 ± 6.01 μm, and that of component CP significantly increased, to about 11.85 ± 5.86 μm. The short-circuit transition mode of cold metal transfer technology and the heterogeneous nucleation effect of primary Al₃(Sc, Zr) and Al₃(Sc, Zr, Ti) phases together promoted the formation of equiaxed grains and refined the microstructures. After heat treatment at 325 °C and 6 h, nano-Al₃Sc precipitated with a size of about 15-50 nm. The yield strength (YS) of components IW and CP increased from 171 ± 3 to 261 ± 1 MPa and 168 ± 7 to 240 ± 17 MPa, respectively. Component IW had the highest ultimate tensile strength, about 400 ± 1 MPa. For WAAM-processed Al-Mg-Sc-Zr alloys, the contribution of the strengthening mechanism to YS was solid solution strengthening > precipitation strengthening > fine grain strengthening > dislocation strengthening.

Key words: Wire arc additive manufacturing, Al-Mg-Sc-Zr alloy, Porosity, Microstructure, Second phase, Mechanical property