Numerical Modelling and Experimental Investigation of Microse-gregation in Al-4.45 wt pct Cu: Effect of Dendrite Joining

Abstract

Abstract: A numerical model Alloy/M has been applied to investigate the microsegregation in Al-4.45 wt pct Cu alloy. The calculated data were compared with the experimental measurements for samples solidified at different cooling rates. Discrepancies in solute concentration occur between the experimental observations and calculated results. Reasons for the discrepancies were discussed, and the effect of dendrite joining at a later stage of solidification on the microsegregation was investigated. Calculations that have included this effect showed a better fit with experimental results.

Key words: Microsegregation, Numerical modelling, Dendrite growth, Aluminium alloy, Dendrite joining

H.B.Dong. Numerical Modelling and Experimental Investigation of Microse-gregation in Al-4.45 wt pct Cu: Effect of Dendrite Joining[J]. J Mater Sci Technol, 2005, 21(05): 753-758.

[1]	Xiaoxu Liu, Yong Du, Shuhong Liu, Kaiming Cheng, Zhihong Zhang. Phase equilibria and crystal structure of ternary compounds in Al-rich corner of Al-Er-Y system at 673 and 873K [J]. J. Mater. Sci. Technol., 2021, 60(0): 128-138.
[2]	Z.C. Luo, H.P. Wang. Primary dendrite growth kinetics and rapid solidification mechanism of highly undercooled Ti-Al alloys [J]. J. Mater. Sci. Technol., 2020, 40(0): 47-53.
[3]	A.V. Pozdniakov, R.Yu. Barkov. Microstructure and mechanical properties of novel Al-Y-Sc alloys with high thermal stability and electrical conductivity [J]. J. Mater. Sci. Technol., 2020, 36(0): 1-6.
[4]	Di Zhang, Zhen Zhang, Yanlin Pan, Yanbin Jiang, Linzhong Zhuang, Jishan Zhang, Xinfang Zhang. Current-driving intergranular corrosion performance regeneration below the precipitates solvus temperature in Al-Mg alloy [J]. J. Mater. Sci. Technol., 2020, 53(0): 132-139.
[5]	Yubing Zhang, Jinglian Du, Kang Wang, Huiyuan Wang, Shu Li, Feng Liu. Application of non-equilibrium dendrite growth model considering thermo-kinetic correlation in twin-roll casting [J]. J. Mater. Sci. Technol., 2020, 44(0): 209-222.
[6]	Inime Ime Udoh, Hongwei Shi, Mohammad Soleymanibrojeni, Fuchun Liu, En-Hou Han. Inhibition of galvanic corrosion in Al/Cu coupling model by synergistic combination of 3-Amino-1,2,4-triazole-5-thiol and cerium chloride [J]. J. Mater. Sci. Technol., 2020, 44(0): 102-115.
[7]	Lintao Gui, Mujun Long, Shixin Wu, Hua Zheng, Zhihua Dong, Jianguo Li, Dengfu Chen, Yunwei Huang, Yunwei Huang, Huamei Duan, Levente Vitos. Quantitative effects of phase transition on solute partition coefficient, inclusion precipitation, and microsegregation for high-sulfur steel solidification [J]. J. Mater. Sci. Technol., 2019, 35(10): 2383-2395.
[8]	Zhaoming Li, Haichang Jiang, Yunli Wang, Duo Zhang, Desheng Yan, Lijian Rong. Effect of minor Sc addition on microstructure and stress corrosion cracking behavior of medium strength Al-Zn-Mg alloy [J]. J. Mater. Sci. Technol., 2018, 34(7): 1172-1179.
[9]	Li Gong, Bo Chen, Long Zhang, Yingche Ma, Kui Liu. Effect of cooling rate on microstructure, microsegregation and mechanical properties of cast Ni-based superalloy K417G [J]. J. Mater. Sci. Technol., 2018, 34(5): 811-820.
[10]	Guowei Wang, Jingjing Liang, Yizhou Zhou, Libin Zhao, Tao Jin, Xiaofeng Sun. Variation of crystal orientation during epitaxial growth of dendrites by laser deposition [J]. J. Mater. Sci. Technol., 2018, 34(4): 732-735.
[11]	Niu Pengliang, Li Wenya, Zhang Zhihan, Yang Xiawei. Global and local constitutive behaviors of friction stir welded AA2024 joints [J]. J. Mater. Sci. Technol., 2017, 33(9): 987-990.
[12]	Wang Guowei, Liang Jingjing, Zhou Yizhou, Jin Tao, Sun Xiaofeng, Hu Zhuangqi. Prediction of Dendrite Orientation and Stray Grain Distribution in Laser Surface-melted Single Crystal Superalloy [J]. J. Mater. Sci. Technol., 2017, 33(5): 499-506.
[13]	Giulio Timelli, Daniele Caliari, Jovid Rakhmonov. Influence of Process Parameters and Sr Addition on the Microstructure and Casting Defects of LPDC A356 Alloy for Engine Blocks [J]. J. Mater. Sci. Technol., 2016, 32(6): 515-523.
[14]	P. Nageswara rao, Dharmendra Singh, R. Jayaganthan. Effect of Post Cryorolling Treatments on Microstructural and Mechanical Behaviour of Ultrafine Grained Al-Mg-Si Alloy [J]. J. Mater. Sci. Technol., 2014, 30(10): 998-1005.
[15]	A. Manonukul, A. Salee. Relationship between Atmospheric Dew Point and Sinterability of Al-Si Based Alloy [J]. J. Mater. Sci. Technol., 2013, 29(1): 70-76.

Numerical Modelling and Experimental Investigation of Microse-gregation in Al-4.45 wt pct Cu: Effect of Dendrite Joining

RichHTML

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments