J Mater Sci Technol ›› 2004, Vol. 20 ›› Issue (06): 649-656.

• Research Articles • Previous Articles     Next Articles

Complete Mill Simulation of the Rolling Process of 1660 mm Hot Strip Continuous Mills

Yingrui WANG, Zhenshan CU, Yingjie WANG, Hongmin LIU   

  1. Department of Plasticity Technology, Shanghai Jiao Tong University, Shanghai 200030, China...
  • Received:1900-01-01 Revised:1900-01-01 Online:2004-11-28 Published:2009-10-10
  • Contact: Yingrui WANG

Abstract: The three-dimensional plastic deformations of strip are analyzed using the stream surface strip element method, the elastic deformations of rolls are analyzed using the influence coefficient method, the analyzing and computing model of shape and crown of 4-high mill was established by combining them, and the rolling process of 1660 mm hot strip continuous mills was simulated. The simulated results tally well with the experimental results. The model and the method for simulation of shape analysis and control of hot strip mills were provided.

Key words: Hot strip mill, Stream surface strip element method, Shape, Crown, Unit rolling pressure, Simulation