Dependence of Structure and Magnetic Properties on Annealing Temperature in Fe72.5Cu1Nb2V2Si13.5B9 alloy

J Mater Sci Technol ›› 2003, Vol. 19 ›› Issue (03): 285-286.

• Research Articles • Previous Articles Next Articles

Dependence of Structure and Magnetic Properties on Annealing Temperature in Fe72.5Cu1Nb2V2Si13.5B9 alloy

Chunyan BAN, Wenqing GAO, Guiyi ZENG, Qixian BA, Hualin ZENG

School of Materials and Metallurgy, Northeastern University, Shenyang 110004, China

Received:1900-01-01 Revised:1900-01-01 Online:2003-05-28 Published:2009-10-10
Contact: Chunyan BAN

Abstract

Abstract: The magnetic properties of Fe72.5Cu1Nb2V2Si13.5B9 alloy are investigated from an amorphous to a nanocrystalline and complete crystalline state. The sample annealed at 550℃ for 0.5 h shows a homogeneous nanocrystalline structure and presents excellent soft magnetic properties. When the specimens were annealed at a temperature above 600℃, the magnetic properties are obviously deteriorated because the grain size grows up, exceeding the exchange length.

Key words: Fe72.5Cu1Nb2V2Si13.5B9 alloy, Soft magnetic properties, Nanocrystalline structure, Grain size

Chunyan BAN, Wenqing GAO, Guiyi ZENG, Qixian BA, Hualin ZENG. Dependence of Structure and Magnetic Properties on Annealing Temperature in Fe72.5Cu1Nb2V2Si13.5B9 alloy[J]. J Mater Sci Technol, 2003, 19(03): 285-286.

[1]	H.T. Jeong, W.J. Kim. Grain size and temperature effect on the tensile behavior and deformation mechanisms of non-equiatomic Fe₄₁Mn₂₅Ni₂₄Co₈Cr₂ high entropy alloy [J]. J. Mater. Sci. Technol., 2020, 42(0): 190-202.
[2]	Xiankun Ji, Baoqi Guo, Fulin Jiang, Hong Yu, Dingfa Fu, Jie Teng, Hui Zhang, John J.Jonas. Accelerated flow softening and dynamic transformation of Ti-6Al-4V alloy in two-phase region during hot deformation via coarsening α grain [J]. J. Mater. Sci. Technol., 2020, 36(0): 160-166.
[3]	Yinchuan Wang, Hua Huang, Gaozhi Jia, Guizhou Ke, Jian Zhang, Guangyin Yuan. Effect of grain size on the mechanical properties of Mg foams [J]. J. Mater. Sci. Technol., 2020, 58(0): 46-54.
[4]	Wei Li, Martina Vittorietti, Geurt Jongbloed, Jilt Sietsma. The combined influence of grain size distribution and dislocation density on hardness of interstitial free steel [J]. J. Mater. Sci. Technol., 2020, 45(0): 35-43.
[5]	Peipei Ma, Chunhui Liu, Qiuyu Chen, Qing Wang, Lihua Zhan, Jianjun Li. Natural-ageing-enhanced precipitation near grain boundaries in high-strength aluminum alloy [J]. J. Mater. Sci. Technol., 2020, 46(0): 107-113.
[6]	A.G. Wang, X.H. An, J. Gu, X.G. Wang, L.L. Li, W.L. Li, M. Song, Q.Q. Duan, Z.F. Zhang, X.Z. Liao. Effect of grain size on fatigue cracking at twin boundaries in a CoCrFeMnNi high-entropy alloy [J]. J. Mater. Sci. Technol., 2020, 39(0): 1-6.
[7]	Xumin Zhu, Congyang Gong, Yun-Fei Jia, Runzi Wang, Chengcheng Zhang, Yao Fu, Shan-Tung Tu, Xian-Cheng Zhang. Influence of grain size on the small fatigue crack initiation and propagation behaviors of a nickel-based superalloy at 650 °C [J]. J. Mater. Sci. Technol., 2019, 35(8): 1607-1617.
[8]	C. Guillén, J. Herrero. P-type SnO thin films prepared by reactive sputtering at high deposition rates [J]. J. Mater. Sci. Technol., 2019, 35(8): 1706-1711.
[9]	Shengyu Jiang, Ruihong Wang. Grain size-dependent Mg/Si ratio effect on the microstructure and mechanical/electrical properties of Al-Mg-Si-Sc alloys [J]. J. Mater. Sci. Technol., 2019, 35(7): 1354-1363.
[10]	Gábor Ribárik, Bertalan Jóni, Tamás Ungár. Global optimum of microstructure parameters in the CMWP line-profile-analysis method by combining Marquardt-Levenberg and Monte-Carlo procedures [J]. J. Mater. Sci. Technol., 2019, 35(7): 1508-1514.
[11]	M.P. Miles, T.W. Nelson, C. Gunter, F.C. Liu, L. Fourment, T. Mathis. Predicting recrystallized grain size in friction stir processed 304L stainless steel [J]. J. Mater. Sci. Technol., 2019, 35(4): 491-498.
[12]	Y.Z. Tian, S.J. Sun, H.R. Lin, Z.F. Zhang. Fatigue behavior of CoCrFeMnNi high-entropy alloy under fully reversed cyclic deformation [J]. J. Mater. Sci. Technol., 2019, 35(3): 334-340.
[13]	Haibin Wang, Mark Gee, Qingfan Qiu, Hannah Zhang, Xuemei Liu, Hongbo Nie, Xiaoyan Song, Zuoren Nie. Grain size effect on wear resistance of WC-Co cemented carbides under different tribological conditions [J]. J. Mater. Sci. Technol., 2019, 35(11): 2435-2446.
[14]	H.K. Yang, K. Cao, Y. Han, M. Wen, J.M. Guo, Z.L. Tan, J. Lu, Y. Lu. The combined effects of grain and sample sizes on the mechanical properties and fracture modes of gold microwires [J]. J. Mater. Sci. Technol., 2019, 35(1): 76-83.
[15]	P. Sharifi, J. Jamali, K. Sadayappan, J.T. Wood. Grain Size Distribution and Interfacial Heat Transfer Coefficient during Solidification of Magnesium Alloys Using High Pressure Die Casting Process [J]. J. Mater. Sci. Technol., 2018, 34(2): 324-334.

Dependence of Structure and Magnetic Properties on Annealing Temperature in Fe72.5Cu1Nb2V2Si13.5B9 alloy

RichHTML

PDF (PC)

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments