J. Mater. Sci. Technol. ›› 2018, Vol. 34 ›› Issue (7): 1172-1179.DOI: 10.1016/j.jmst.2017.11.042

Special Issue: Aluminum Alloys-2018

• Orginal Article • Previous Articles     Next Articles

Effect of minor Sc addition on microstructure and stress corrosion cracking behavior of medium strength Al-Zn-Mg alloy

Zhaoming Liab, Haichang Jianga(), Yunli Wanga, Duo Zhanga, Desheng Yana, Lijian Ronga()   

  1. aCAS Key Laboratory of Nuclear Materials and Safety Assessment, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, China
    bUniversity of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2017-07-02 Revised:2017-10-19 Accepted:2017-11-13 Online:2018-07-10 Published:2018-07-22

Abstract:

Influence of Sc content on microstructure and stress corrosion cracking behavior of medium strength Al-Zn-Mg alloy have been investigated by optical microscopy, scanning electron microscopy, electron backscatter diffraction, transmission electron microscopy and slow strain rate test. The results indicate that the addition of Sc results in the formation of the quaternary coherent Al3(Sc, Zr, Ti) dispersoids during homogenization treatment, which will inhibit the dynamic recrystallization behavior. The number density of Al3(Sc, Zr, Ti) particles increases with the increase of Sc content, and thus the recrystallization fraction of hot-extruded alloy is reduced and the peak strength in two-stage artificial aging sample is enhanced. At the same time, the wide of precipitation free zone is reduced, and the content of Zn and Mg in grain boundary particles and precipitation free zone is increased with the increase of Sc content. In peak-aged state, the 0.06 wt% Sc added alloy shows the better stress corrosion cracking resistance than the Sc-free alloy because of the reduction of recrystallization fraction and the interrupted distribution of grain boundary precipitates along grain boundary. However, the further addition of Sc to 0.11 wt% will result in the deterioration of stress corrosion cracking resistance due to the increase of electrochemical activity of grain boundary particles and precipitation free zone as well as hydrogen embrittlement.

Key words: Aluminium alloy, Al3(Sc,Zr,Ti), Recrystallization, Stress corrosion cracking