Behavior of AISI 316L steel subjected to uniaxial state of stress at elevated temperatures

J. Mater. Sci. Technol. ›› 2009, Vol. 25 ›› Issue (02): 175-180.

Behavior of AISI 316L steel subjected to uniaxial state of stress at elevated temperatures

Josip Brni?¹;牛济泰²

1. Faculty of Engineering; University of Rijeka; Croatia
2. 哈尔滨工业大学现代焊接生产技术国家重点实验室

收稿日期:2008-09-22 修回日期:2009-02-20 出版日期:2009-03-28 发布日期:2009-10-10
通讯作者: Josip Brni?

Behavior of AISI 316L Steel Subjected to Uniaxial State of Stress at Elevated Temperatures

Josip Brnic^1)†, Jitai Niu²⁾, Marko Canadija¹⁾, Goran Turkalj¹⁾ and Domagoj Lanc¹⁾

1) Faculty of Engineering, University of Rijeka, Croatia
2) The State Key Laboratory of Advanced Welding Production Technology, Harbin Institute of Technology, Harbin 150001, China

Received:2008-09-22 Revised:2009-02-20 Online:2009-03-28 Published:2009-10-10
Supported by:
the Ministry of Science and Technology of the Republic of Croatia

摘要/Abstract

关键词: mechanical properties;high temperature deformation;creep;AISI 316L

Abstract:

This paper presents an experimental investigation on an AISI 316L stainless steel regarding mechanical properties and short uniaxial creep tests at elevated temperatures. The short time creep tests were carried out under different but constant stresses. The obtained data of ultimate tensile strength, yield strength, creep curves and effects of elevated temperatures on mechanical properties were presented. For a selected rheological model, material parameters were obtained. As a justification, such rheological model is implemented in the finite element procedure for an uniaxially stressed specimen in selected environmental conditions.

Key words: Mechanical properties, High temperature deformation, Creep, AISI 316L

Josip Brni? 牛济泰. Behavior of AISI 316L steel subjected to uniaxial state of stress at elevated temperatures[J]. J. Mater. Sci. Technol., 2009, 25(02): 175-180.

Josip Brnic,Jitai Niu,Marko Canadija,Goran Turkalj,Domagoj Lanc. Behavior of AISI 316L Steel Subjected to Uniaxial State of Stress at Elevated Temperatures[J]. J Mater Sci Technol, 2009, 25(02): 175-180.

参考文献

[1 ] Z.P. Bazant and L. Cedolin: Stability of Structures, Oxford University Press, New York, 1991.
[2 ] A.P. Boresi, R.J. Schmidt and O.M. Sidebottom: Advanced Mechanics of Materials, John Wiley & Sons, New York, 1993.
[3 ] P.F. Timmins: ASM Int., 1997, 19, 468.
[4 ] T.H. Courtney: ASM Int., 1997, 20, 336.
[5 ] D.A. Woodford: ASM Int., 1997, 20, 573.
[6 ] W.N. Findley, J.S. Lai and K. Onaran: Creep and Relaxation of Nonlinear Viscoelastic Materials, Dover Publications, New York, 1989.
[7 ] P.L. Tallec: Numerical Analysis of Viscoelastic Problems, Springer-Verlag, Berlin, 1990.
[8 ] A.D. Drozdov: Finite Elasticity and Viscoelasticity, World Scientific Publishing, London, 1996.
[9 ] S.G. Hong and S.B. Lee: Int. J. Fatigue, 2004, 26, 899.
[10] D.J. Smith and E.G. Ellison: Int. J. Press. Ves. Pip., 1992, 50, 231.
[11] R.F. Martins and C.M. Branco: Fatigue Fract. Eng. M., 2004, 27, 861.
[12] Q. Auzoux, L. Allais, C. Caes, B. Girard, I. Tournie, A.F. Gourgues and A. Pineau: Nucl. Eng. Des., 2005, 235, 2227.
[13] R.C. Hurst and S. McAllister: Nucl. Eng. Des., 1995, 158, 253.
[14] M.D. Mathew, S. Latha and K.B.S. Rao: Mater. Sci. Eng. A, 2007, 456, 28.
[15] L. Allais, J.P. Dessalas, T. Forgeron, D. Francois, H. Huthmann, C. Escaravage, C. Poette and H. Sassoulas: Fatigue Fract. Eng. M., 1998, 21, 791
[16] G. Bouche, L. Allais, V. Lezaud, R. Piques and A. Pineau: Mater. High Temper., 1998, 15, 403.
[17] C.G. Shastry, P. Parameswaran, M.D. Mathew, K.B.S. Rao, and S.D. Pathak: Mater. Sci. Eng. A, 2008, 473, 133.
[18] M.D. Mathew, G. Sasikala, K.B.S. Rao and S.L. Mannan: Mater. Sci. Eng. A, 1991, 148, 253.
[19] Annual Book of ASTM Standards: Metal Test Methods and Analytical Procedures, Vol. 03.01, ASTM International, Baltimore, 2005.
[20] Y.Y. Yang, M. Mahfouf and D.A. Linkens: J. Mater. Sci. Technol., 2003, 19(Suppl.1), 5.
[21] Fracture Mechanics Properties of Carbon and Alloy
Steels, In Fatigue and Fracture, Vol. 19, ASM International, Materials Park (OH)) 1997, 614.
[22] B.L. Bramfitt: Effects of Composition, Processing and Structure on Properties of Irons and Steels, In Materials Selection and Design, Vol. 20, ASM International, Materials Park (OH) 1997., 357.
[23] W.J. Mills: Fracture Toughness of Austenitic Stainless Steels and Their Welds, In Fatigue and Fracture, Vol. 19, ASM International, Materials Park (OH)), 1997, 733.

Behavior of AISI 316L steel subjected to uniaxial state of stress at elevated temperatures

Behavior of AISI 316L Steel Subjected to Uniaxial State of Stress at Elevated Temperatures

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价