Investigation of the grain size effect on the martensite formation in a high manganese TWIP steel by the Rietveld method

J. Mater. Sci. Technol. ›› 2010, Vol. 26 ›› Issue (2): 181-186.

• Research Articles • 上一篇下一篇

Investigation of the grain size effect on the martensite formation in a high manganese TWIP steel by the Rietveld method

Ghasem Dini¹;Abbas Najafizadeh²;Sayed Mahmoud Monir Vaghefi²

1. Isfahan University of Technology
2.

收稿日期:2009-01-05 修回日期:2009-07-06 出版日期:2010-02-28 发布日期:2010-02-28
通讯作者: Ghasem Dini

Grain Size Effect on the Martensite Formation in a High-Manganese TWIP Steel by the Rietveld Method

G. Dini¹⁾, A. Najagizadeh¹⁾, S.M. Monir-Vaghefi¹⁾, R. Ueji²⁾

1) Department of Materials Engineering, Isfahan University of Technology, Isfahan 84156-83111, Iran
2) Department of Advanced Materials Science, Faculty of Engineering, Kagawa University, 2217-20, Hayashi-cho, Takamatsu, Kagawa, 761-0396, Japan

Received:2009-01-05 Revised:2009-07-06 Online:2010-02-28 Published:2010-02-28
Contact: G. Dini

摘要/Abstract

摘要：

The aim of the present work is to study the effect of austenite grain size (AGS) on the martensite formation in a high manganese TWIP steel. The results of a quantitative microstructural characterization of the steel by the whole X-ray pattern-fitting Rietveld software, MAUD, indicated that the volume fraction of Alpha (bcc)-martensite increases with increasing AGS. However, the value of the stacking fault probability (Psf) does not show a large variation for samples with different values of AGS under water-quenched conditions.

关键词: Austenite grain size, martensite formation, TWIP steel, stacking fault probability

Abstract:

The aim of the present work was to study the effect of austenite grain size (AGS) on the martensite formation in a high-manganese twinning-induced plasticity (TWIP) steel. The results of a quantitative microstructural characterization of the steel by the whole X-ray pattern fitting Rietveld software, materials analysis using diffraction (MAUD), indicated that the volume fraction of ffbcc-martensite increases with increasing AGS. However, the value of the stacking fault probability (Psf ) does not show a large variation for samples with different values of AGS under water-quenching conditions.

Key words: Austenite grain size, Martensite formation, TWIP steel, Stacking fault probability

Ghasem Dini Abbas Najafizadeh Sayed Mahmoud Monir Vaghefi. Investigation of the grain size effect on the martensite formation in a high manganese TWIP steel by the Rietveld method[J]. J. Mater. Sci. Technol., 2010, 26(2): 181-186.

G. Dini, A. Najagizadeh, S.M. Monir-Vaghefi, R. Ueji. Grain Size Effect on the Martensite Formation in a High-Manganese TWIP Steel by the Rietveld Method[J]. J Mater Sci Technol, 2010, 26(2): 181-186.

参考文献

[1 ] Z.L. Mi, D. Tang, L. Yan and J. Guo: J. Mater. Sci. Technol., 2005, 21(4), 451.
[2 ] H. Ding, Z.Y. Tang, W. Li, M. Wang and D. Song: Int. J. Iron Steel Res., 2006, 13(6), 66.
[3 ] O. GrÄassel, L. Kruger, G. Frommeyer and L.W. Meyer: Int. J. Plasticity, 2000, 16, 1391.
[4 ] U. Brux, G. Frommeyer, O. GrÄassel, L.W. Meyer and A. Weise: Steel Res., 2002, 73, 294.
[5 ] G. Frommeyer, U. Brux and P. Neumann: ISIJ Int., 2003, 43(3), 438.
[6 ] S. Allain, J.P. Chateau, O. Bouaziz, S. Migot and N. Guelton: Mater. Sci. Eng. A, 2004, 387{389, 158.
[7 ] A. Sato, K. Soma and T. Mori: Acta Metall., 1982, 30, 1901.
[8 ] G.B. Olson and M. Cohen: Metall. Trans. A, 1976, 7, 1897.
[9 ] M. Hadji and R. Badji: J. Mater. Eng. Perform., 2002, 11(2), 145.
[10] Y. Nihei, Y. Hiraoka, Y. Kagaya, Y. Kohno, K. Shibata and H. Ohtsuka: J. Nucl. Mater., 2004, 329{ 333, 648.
[11] L. Lutterotti: MAUD, Version 2.072, http://www.ing. unitn.it/.
[12] H.M. Rietveld: J. Appl. Crystallogr., 1969, 2, 65.
[13] A. Chanda and M. De: J. Alloy. Compd., 2000, 313, 104.
[14] P. Sahu, M. De and S. Kajiwara: J. Alloy. Compd., 2002, 346, 158.
[15] P. Sahu, A.S. Hamada, R.N. Ghosh and L.P. Karjalainen: Metall. Mater. Trans. A, 2007, 38, 1991.
[16] L. Lutterotti, P. Scardi and P. Maitrelli: J. Appl. Crystallogr., 1990, 23, 246.
[17] D. Chateigner: Combined Analysis, http://www.ecole. ensicaen.fr/ chateign/texture/combined.pdf.
[18] B.Y. Warren: X-ray Diffraction, Addison-Wesley, Reading, Massachusetts, 1969, 289.
[19] O. GrÄossel, G. Frommeyer, C. Derder and H. Hofmann: J. Phy. IV, 1997, 7, 383.
[20] B.H. Jiang, X. Qe, W. Zhou and T.Y. Hsu: Scripta Mater., 1996, 34, 771.
[21] T.N. Durlu: J. Mater. Sci. Lett., 1997, 32, 320.
[22] J.H. Jun and C.S. Choi: Mater. Sci. Eng. A, 1998, 257, 353.
[23] Y.K. Lee and C.S. Choi: Metall. Mater. Trans. A, 2000, 31, 355.
[24] B.H. Jiang, L. Sun, R. Li and T.Y. Hsu: Scripta Metall., 1995, 33, 63.

Investigation of the grain size effect on the martensite formation in a high manganese TWIP steel by the Rietveld method

Grain Size Effect on the Martensite Formation in a High-Manganese TWIP Steel by the Rietveld Method

RichHTML

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价