J. Mater. Sci. Technol. ›› 2019, Vol. 35 ›› Issue (6): 1064-1073.DOI: 10.1016/j.jmst.2018.12.008

Previous Articles     Next Articles

Tailoring the secondary phases and mechanical properties of ODS steel by heat treatment

Qian Zhao, Zongqing Ma*(), Liming Yu, Huijun Li, Chenxi Liu, Chong Li, Yongchang Liu*()   

  1. State Key Lab of Hydraulic Engineering Simulation and Safety, School of Materials Science & Engineering, Tianjin University, Tianjin 300354, China
  • Received:2018-03-19 Revised:2018-10-19 Accepted:2018-11-26 Online:2019-06-20 Published:2019-06-19
  • Contact: Ma Zongqing,Liu Yongchang
  • About author:

    1The authors contributed equally to this work.

Abstract:

The oxide dispersion strengthened (ODS) steel with the nominal composition of Fe-14Cr-2W-0.3Ti-0.2V-0.07Ta-0.3Y2O3 (wt%) was fabricated by mechanical alloying and hot isostatic pressing (HIP). In order to optimize the relative volume fraction of secondary phases, the as-HIPed ODS steel was annealed at 800 °C, 1000 °C, 1200 °C for 5 h, respectively. The microstructures and different secondary phases of the as-HIPed and annealed ODS samples were identified by scanning electron microscopy (SEM), transmission electron microscopy (TEM), and X-ray diffraction (XRD). The tensile properties of all the ODS steels at room temperature were also investigated. The results indicate that annealing is an effective way to control the microstructure and the integral secondary phases. The annealing process promotes the dissolution of M23C6 particles, thus promoting the precipitation of TiC. No obvious coarsening of Y2Ti2O7 nanoparticles can be observed during annealing. The tensile results indicate that the annealed ODS sample with the optimized secondary phases and high density possesses the best mechanical properties.

Key words: ODS steel, Annealing, Secondary phase, Mechanical property