J. Mater. Sci. Technol. ›› 2018, Vol. 34 ›› Issue (12): 2458-2463.DOI: 10.1016/j.jmst.2018.05.010

• Orginal Article • Previous Articles     Next Articles

Introduction of porous structure: A feasible and promising method for improving thermoelectric performance of Bi2Te3 based bulks

Jie Huab, Xi’An Fanab*(), Chengpeng Jiangab, Bo Fengab, Qiusheng Xiangab, Guangqiang Liab, Zhu Heab, Yawei Liabc   

  1. a The State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology, Wuhan, 430081, China
    b Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education, Wuhan University of Science and Technology, Wuhan, 430081, China
    c National-provincial Joint Engineering Research Center of High Temperature Materials and Lining Technology, Wuhan University of Science and Technology, Wuhan, 430081, China
  • Received:2018-01-02 Revised:2018-02-07 Accepted:2018-03-17 Online:2018-12-20 Published:2018-11-15
  • Contact: Fan Xi’An

Abstract:

The porous p-type Bi0.4Sb1.6Te3 bulks containing irregularly and randomly oriented pores were obtained by artificially controlling the relative density of sintered samples during resistance pressing sintering process. It is demonstrated that the thermoelectric performances are significantly affected by the porous structure, especially for the electrical and thermal conductivity due to the enhanced carrier scattering and phonon scattering. The increasing porosity resulted in the obvious decrease in electrical and thermal conductivity, and little change in Seebeck coefficients. It is encouraging that the reduction of thermal conductivity can compensate for the deterioration of electrical performance, leading to the enhancement in thermoelectric figure of merit (ZT). The maximum ZT value of 1.0 was obtained for the sample with a relative density of 90% at 333?K. Unfortunately, the increase in porosity also brought in obvious degradations in Vickers hardness from 51.71 to 27.74?HV. It is worth mentioning that although the Vickers hardness of the sample with a relative density of 90% decreased to 40.12?HV, it was still about twice as high as that of the zone melting sample (21.25?HV). To summarize, introducing pores structure into bulks properly not only enhances the ZT value of Bi2Te3 based alloys, but also reduces the use of raw materials and saves production cost.

Key words: Thermoelectric materials, Porous structure, Bi2Te3, Thermal conductivity, Vickers hardness